Laser cutters usually work much like a milling machine would for working a sheet in that the laser (equivalent to the mill) enters through the side of the sheet and cuts it through the axis of the beam. In order to be able to start cutting from somewhere else than the edge, a pierce is done before every cut. Piercing usually involves a high power pulsed laser beam which slowly (taking around 5-15 seconds for half-inch thick stainless steel, for example) makes a hole in the material.
There are many different methods in cutting using lasers, with different types used to cut different material. Some of the methods are vaporization, melt and blow, melt blow and burn, thermal stress cracking, scribing, cold cutting and burning stabilized laser cutting.
Vaporization cutting
In vaporization cutting the focused beam heats the surface of the material to boiling point and generates a keyhole. The keyhole leads to a sudden increase in absorptivity quickly deepening the hole. As the hole deepens and the material boils, vapor generated erodes the molten walls blowing ejecta out and further enlarging the hole. Non melting material such as wood, carbon and thermoset plastics are usually cut by this method.
Melt and blow
Melt and blow or fusion cutting uses high pressure gas to blow molten material from the cutting area, greatly decreasing the power requirement. First the material is heated to melting point then a gas jet blows the molten material out of the kerf avoiding the need to raise the temperature of the material any further. Materials cut with this process are usually metals.
Thermal stress cracking
Brittle materials are particularly sensitive to thermal fracture, a feature exploited in thermal stress cracking. A beam is focused on the surface causing localized heating and thermal expansion. This results in a crack that can then be guided by moving the beam. The crack can be moved in order of m/s. It is usually used in cutting of glass.
Burning stabilized laser gas cutting
Burning stabilized laser cutting is essentially oxygen cutting but with a laser beam as the ignition source. This process can be used to cut very thick steel plates with relatively little laser power.
Machine configurations
There are generally three different configurations of industrial laser cutting machines: Moving material, Hybrid, and Flying Optics systems. These refer to way that the laser beam is moved over the material to be cut or processed. For all of these, the axes of motion are typically designated X and Y. axis. If the cutting head may be controlled, it is designated as the Z-axis.
Moving material lasers have a stationary cutting head and move the material under it. This method provides a constant distance from the laser generator to the workpiece and a single point from which to remove cutting effluent. It requires fewer optics, but requires moving the workpiece.
Hybrid lasers provide a table which moves in one axis (usually the X-axis) and move the head along the shorter (Y) axis. This results in a more constant beam delivery path length than a flying optic machine and may permit a simpler beam delivery system. This can result in reduced power loss in the delivery system and more capacity per watt than flying optics machines.
Flying optics lasers feature a stationary table and a cutting head (with laser beam) that moves over the work piece in both of the horizontal dimensions. Flying-optics cutters keep the workpiece stationary during processing, and often don't require material clamping. The moving mass is constant, so dynamics aren't affected by varying size and thickness of workpiece. Flying optics machines are the fastest class of machines, with higher accelerations and peak velocities than hybrid or moving material systems.
Dual Pallet Flying Optics Laser
Flying optic machines must use some method to take into account the changing beam length from near field (close to resonator) cutting to far field (far away from resonator) cutting. Common methods for controlling this include collimation, adaptive optics or the use of a constant beam length axis.
The above is written about X-Y systems for cutting flat materials. The same discussion applies to five and six-axis machines, which permit cutting formed workpieces. In addition, there are various methods of orienting the laser beam to a shaped workpiece, maintaining a proper focus distance and nozzle standoff, etc.
没有评论:
发表评论